Cisco C9200L-24P-4X User Manual

Figure 37: Site Profile - Access Switches
Figure 38: Site Profile - Access Switches (with Routed Access)
Table 13: Default Configuration Loaded with Each Site Profile (Distribution Switches)
Redundant Distribution
Switch (Port Channel
Peer and Downlink)
Single Distribution
Switch (Single Port
Channel Downlink)
Single Distribution
Switch (Single Downlink)
Setting
The hostname or device
name you provided as part
of Quick Setup
The hostname or device
name you provided as part
of Quick Setup
The hostname or device
name you provided as part
of Quick Setup
Hostname
RPVST+RPVST+RPVST+Spanning Tree Mode
Mode TransparentMode TransparentMode TransparentVTP
EnabledEnabledEnabledUDLD
Recovery mode set to
Auto
Recovery mode set to
Auto
Recovery mode set to
Auto
Error Disable Recovery
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
56
Configuring the Switch
Configuring Your Device Based on a Site Profile

Cisco C9200L-24P-4X Specifications

General

Model	C9200L-24P-4X
Device Type	Switch
Enclosure Type	Rack-mountable
Ports	24 x 10/100/1000 (PoE+)
Switching Capacity	128 Gbps
Forwarding Rate	95.23 Mpps
PoE Budget	370W
Layer	Layer 3
Stacking Bandwidth	80 Gbps
RAM	4 GB
Flash Memory	4 GB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Uplink Interfaces	4 x 10 Gigabit Ethernet
MAC Address Table Size	16000 entries
Routing Protocol	OSPF, BGP, EIGRP, RIP
Remote Management Protocol	SNMP, CLI, HTTP, HTTPS, SSH
Features	Energy Efficient Ethernet, DHCP snooping, QoS, VLAN support, ACLs
Compliant Standards	IEEE 802.3, IEEE 802.3af, IEEE 802.3at, IEEE 802.1x
Operating Temperature	0 to 45 °C
Operating Humidity	5% to 90% (non-condensing)