EasyManuals Logo

Cisco C9200L-24P-4X User Manual

Cisco C9200L-24P-4X
90 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #85 background image
4
Only switches with PoE+ ports.
Table 27: Meaning of Switch LED Colors in Different Modes
MeaningPort LED ColorPort Mode
No link, or port was administratively shut down.OffSTAT (port status)
Link present, no activity.Green
Activity. Port is sending or receiving data.Blinking green
Link fault. Error frames can affect connectivity, and errors
such as excessive collisions, CRC errors, and alignment
and jabber errors are monitored for a link-fault indication.
Alternating green-amber
Port is blocked by Spanning Tree Protocol (STP) and is
not forwarding data.
After a port is reconfigured, the port LED can be amber
for up to 30 seconds as STP checks the switch for possible
loops.
Amber
10/100/1000/SFP portsSPEED
Port is operating at 10 Mb/s.Off
Port is operating at 100 Mb/s.Green
Port is operating at 1000 Mb/s.Single green flash (on for
100 ms, off for 1900 ms)
Uplink ports
Port is not operating.
Off
Port is operating at up to 10 Gb/s.Blinking green
Port is operating in half duplex.
OffDUPLX (duplex)
Port is operating in full duplex.Green
The switch is not the active switch.
For a standalone switch, this LED is off.
Note
OffACTV (data active
switch)
The switch is the active switch.Green
Error during active switch election.Amber
Switch is a standby member of a data stack and assumes
active responsibilities if the current active switch fails.
Blinking green
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
79
Switch LEDs
Switch LEDs

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco C9200L-24P-4X and is the answer not in the manual?

Cisco C9200L-24P-4X Specifications

General IconGeneral
ModelC9200L-24P-4X
Device TypeSwitch
Enclosure TypeRack-mountable
Ports24 x 10/100/1000 (PoE+)
Switching Capacity128 Gbps
Forwarding Rate95.23 Mpps
PoE Budget370W
LayerLayer 3
Stacking Bandwidth80 Gbps
RAM4 GB
Flash Memory4 GB
Power DeviceInternal power supply
Voltage RequiredAC 120/230 V (50/60 Hz)
Uplink Interfaces4 x 10 Gigabit Ethernet
MAC Address Table Size16000 entries
Routing ProtocolOSPF, BGP, EIGRP, RIP
Remote Management ProtocolSNMP, CLI, HTTP, HTTPS, SSH
FeaturesEnergy Efficient Ethernet, DHCP snooping, QoS, VLAN support, ACLs
Compliant StandardsIEEE 802.3, IEEE 802.3af, IEEE 802.3at, IEEE 802.1x
Operating Temperature0 to 45 °C
Operating Humidity5% to 90% (non-condensing)

Related product manuals