6
Cisco Catalyst 9120AX Series Access Points
Warning
Installation of the equipment must comply with local and national electrical codes.
Statement 1074
Warning
In order to comply with FCC radio frequency (RF) exposure limits, antennas should be located at a
minimum of 12 inches (30 cm) or more from the body of all persons.
Statement 332
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Warning
The access point, antennas, and all interconnected equipment including the associated LAN
connections must be located indoors within the same building.
Statement 375
Warning
This equipment is suitable for use in environment air spaces (plenums) in accordance with Section
300.22 (C) of the National Electrical Code, and Sections 2-128, 12-010(3) and 12-100 of the Canadian
Electrical Code, Part 1, CSA C22.2. External power supply, power adapter and/or power injector, if
provided, are not suitable for installation in air spaces.
Statement 440
4 Unpacking
To unpack the access point, follow these steps:
Step 1 Unpack and remove the access point and the accessory kit from the shipping box.
Step 2 Return any packing material to the shipping container and save it for future use.
Step 3 Verify that you have received the items listed below. If any item is missing or damaged, contact your Cisco
representative or reseller for instructions.
— The access point
— Mounting bracket (AIR-AP-BRACKET-1=, selected when you ordered the access point)
— Adjustable ceiling-rail clip (selected when you ordered the access point)
— Power Injector AIR-PWRINJ6= (only if selected when you ordered the access point).
To Next Page
Loading...
Need help?
General
