• The Underwriter Laboratories (UL)-approved Listed Power Adapter
must meet the following minimum specifications: Rated output of 42.5
to 57 Vdc, min. 1.11A, Tma of 50°C minimum, altitude of 3048m
minimum.
• If 802.3af is used, all the radios get switched off. Ethernet gets
downgraded to 1 GbE. The USB port is also off.
Note
• Operating temperature:
• CW9164I: 32°F to 122°F (0°C to 50°C)
When installing the AP in an environment where the ambient temperature
is in the range of 104°and 122°F (>40° and 50°C), the access point
configuration changes from 4x4 on the 5-GHz radios, and the uplink Ethernet
will downgrade to 1 GbE. However, the USB port remains enabled.
Note
• Console access using the console port
We recommend that you use a console cable that is one meter or less in length.
The AP may face issues while booting if you use an unterminated console
cable (not plugged into any device or terminal) or a console cable that is
more than one meter in length.
Note
We recommend that you make a site map showing access point locations so that you can record the device
MAC addresses from each location and return them to the person who is planning or managing your wireless
network.
Mounting the Access Point
Cisco Catalyst 9164 Series Wi-Fi 6E Access Point can be mounted in the following places:
• Suspended ceiling
• Hard ceiling
• Wall
• Electrical or network box
• Above a suspended ceiling
• Desk mount
For detailed instructions on mounting the AP, see the Access Point Mounting Instructions document at:
Cisco Catalyst 9164 Series Wi-Fi 6E Access Point Hardware Installation Guide
18
Installation Overview
Mounting the Access Point
To Next Page
Loading...
Need help?
General
