Cisco Catalyst 9407R Installation Note

Cisco Catalyst 9400 Series Switching Module LEDs
Table 2: Cisco Catalyst 9400 Series Switching Module LEDs
MeaningLED ColorLED
All diagnostic tests have passed and the module is operational.Green
STATUS
The module is booting or running diagnostics or the module is disabled.Amber
A test other than an individual port test has failed. On some modules, this
LED turns red immediately after the system is powered on, until the software
boot process begins.
Red
The module is disabled or is not powered up.Off
Identifies the module receiving the beacon signal.
Blue
LOCATE
Port link is up but there is no packet activity.Green
PORT LINK
Port link is up and indicating packet activity.Blinking Green
Port link is disabled by the user, that is, administratively down.Amber
Hardware (PHY) has detected a faulty port link.Blinking Amber
Error packets are being detected on the port link. The error packets could
be bad Cyclic Redundancy Check (CRC) packets, jumbo packets, and so
on.
Alternating Green and
Amber
No signal is detected, the link is down, or the port is not connected.Off
Removing and Replacing Switching Modules
All Cisco Catalyst 9400 Series Modules support hot swapping, which lets you install, remove, replace, and rearrange switching
modules without powering off the system. When the system detects that a switching module has been installed or removed, it runs
diagnostic and discovery routines automatically, acknowledges the presence or absence of the module, and resumes the system
operation with no operator intervention.
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning
22

Cisco Catalyst 9407R Specifications

General

Brand	Cisco
Model	Catalyst 9407R
Category	Switch
Language	English