Cisco Catalyst 9600 Series Installation Note

Table 8: Features Supported on Cisco Catalyst 9600 Series 48-Port 10 G/5 G/2.5 G/1 G/100 Mbps/10 Mbps (C9600-LC-48TX)
DescriptionFeature
• 48 RJ45 copper ports of 10 G, 5 G, 2.5 G, 1 G, 100 Mbps and
10 Mbps: Provides 48 10 G, 5 G, 2.5 G, 1 G, 100 Mbps and 10
Mbps interfaces by default. These ports can be interchangeably
used as 10 G, 5 G, 2.5 G, 1 G, 100 Mbps and 10 Mbps ports.
• All the 48 ports support 10 G, 5 G, 2.5 G, 1 G, 100 Mbps and
10 Mbps speeds.
Ports per module
C9606R: Slots 1, 2, 5, and 6 only. However, you can install a line
card in any of the supported slots.
Chassis slot restrictions
2.4 Tbps per slotBandwidth per slot
Line Card LEDs
Table 9: Line Card LEDs
MeaningLED Position or ColourLED Type
Module is receiving beacon signal.Blue
Blue Beacon
Port link is up.Green
Port Link
Port link is disabled, that is, administratively down.Amber
No signal is detected, the link is down, or the port is
not connected.
Off
Preparing for Installation and Removal of a Line Card
Safety Warnings
Safety warnings appear throughout this publication in procedures that may harm you if you perform them
incorrectly. A warning symbol precedes each warning statement. The warnings below are general warnings
that are applicable to the entire publication.
An exposed wire lead from a DC-input power source can conduct harmful levels of electricity. Be sure that
no exposed portion of the DC-input power source wire extends from the connector(s) or terminal block(s).
Statement 122
Warning
Cisco Catalyst 9600 Series Line Card Installation Note
7
Line Card LEDs

Cisco Catalyst 9600 Series Specifications

General

Brand	Cisco
Model	Catalyst 9600 Series
Category	Switch
Language	English