Cisco Catalyst C9300-NM-8X User Manual

Figure 3: Network Module with Pluggable Transceiver Modules Installed
Removing Cisco Pluggable Transceiver Modules
Procedure
Step 1 Attach an ESD-preventive wrist strap to your wrist and to an earth ground surface.
Step 2 Disconnect the cable from the transceiver module. For reattachment, note which cable connector plug is send
(TX) and which is receive (RX).
Step 3 Insert a dust plug into the optical ports of the transceiver module to keep the optical interfaces clean.
Step 4 If the transceiver module has a bale-clasp latch, pull the bale out and down to eject the module. If you cannot
use your finger to open the latch, use a small, flat-blade screwdriver or other long, narrow instrument to open
it.
Step 5 Grasp the transceiver module, and carefully remove it from the slot.
Step 6 Place the transceiver module in an antistatic bag or other protective environment.
Finding the Network Module Serial Number
If you contact Cisco Technical Assistance regarding a network module, you need to know its serial number.
Installing a Network Module
12
Installing a Network Module
Removing Cisco Pluggable Transceiver Modules

Cisco Catalyst C9300-NM-8X Specifications

General

Brand	Cisco
Model	Catalyst C9300-NM-8X
Category	Switch
Language	English