Cisco Firepower 4100 Series User Manual

For More Information
• See 10-Gb Network Module, on page 12 for a description of the 10-GB network module.
• See 40-Gb Network Module, on page 13 for a description of the 40-GB network module.
• See 100-Gb Network Module (Two Ports, Single Wide), on page 14 for a description of the two-port
100-Gb network module.
• See 100-Gb Network Module (Four Ports, Single Wide), on page 15 for a description of the four-port
100-Gb network module.
• See Hardware Bypass Network Modules, on page 16 for the location and description of the LEDs,
and the port configurations for the hardware bypass network modules.
• See Install, Remove, and Replace the Network Module for the procedure for removing and replacing
network modules.
10-Gb Network Module
The following figure shows the front panel of the 10-Gb network module (FPR4K-NM-8X10G). The
FPR4K-NM-8X10G is a single-wide module that supports hot swapping. The eight ports are numbered from
top to bottom, left to right.
Make sure you have the correct firmware package and software version installed to support this network
module. For instructions on how to verify your firmware package version and to upgrade the firmware if
necessary, see the Cisco Firepower 4100/9300 FXOS Firmware Upgrade Guide. See Cisco Firepower 4100/9300
FXOS Compatibility for the software compatibility matrix.
Note
The FPR4K-NM-8X10G is NEBS-compliant.
Note
You can fit four copper SFPs in either the top row of ports or the bottom row of ports. Both rows cannot be
populated at the same time, because of the port row spacing.
Note
Overview
12
Overview
10-Gb Network Module

Cisco Firepower 4100 Series Specifications

General

Brand	Cisco
Model	Firepower 4100 Series
Category	Firewall
Language	English