D-8
Cisco Wireless ISR and HWIC Access Point Configuration Guide
OL-6415-04
Appendix D Error and Event Messages
802.11 Subsystem Messages
Error Message DOT11-3-POWERS_INVALID: Interface [interface], no valid power levels
available
Explanation The radio driver found no valid power level settings.
Recommended Action Investigate and correct the power source and settings.
Error Message DOT11-4-RADIO_INVALID_FREQ: Operating frequency [frequency] invalid -
performing a channel scan
Explanation The indicated frequency is invalid for operation. A channel scan is being performed to
select a valid frequency.
Recommended Action None.
Error Message DOT11-2-RADIO_INITIALIZATION_ERROR: The radio subsystem could not be
initialized [characters]
Explanation A critical error was detected while attempting to initialize the radio subsystem.
Recommended Action Reload the system.
Error Message DOT11-4-UPLINK_NO_ID__PWD: Interface [interface], no
username/password supplied for uplink authentication
Explanation The user failed to enter a username and/or password.
Recommended Action Enter the username and/or password and try again.
Error Message DOT11-4-NO_IE_CFG: No IEs configured for [characters] [ssid index]
Explanation When attempting to apply a beacon or probe response to the radio, the beacon or probe
was undefined on the indicated SSID index.
Recommended Action Check the IE configuration.
Error Message DOT11-4-FLASHING_RADIO: Interface [interface], flashing radio firmware
[characters]
Explanation The indicated interface radio has been stopped to load the indicated new firmware.
Recommended Action None.
Error Message DOT11-4-LOADING_RADIO: Interface [interface], loading the radio
firmware [characters]
Explanation The indicated interface radio has been stopped to load new indicated firmware.
Recommended Action None.
To Next Page
Loading...
Need help?
General
