Cisco NCS 1001 Start Guide

Revised: April 13, 2018,
Install NCS 1001-K9 into EIA/ANSI Rack
In an EIA/ANSI rack, NCS 1001 can be installed in the front position.
The rack is not provided by Cisco. Cisco provides only the chassis and the sliding rail.Note
Use only the fastening hardware provided with NCS 1001-K9 to prevent loosening, deterioration, and
electromechanical corrosion of the hardware and joined material.
Caution
It is required to have 100 mm (3.94") space on the front and rear side of the rack to provide sufficient clearance for cable routing and
cooling of the system.
In case of a closed cabinet, the cabinet must support the thermal management or front/rear doors need to have 70% perforation. Closed
cabinets must have adequate airflow to dissipate maximum power from equipments in a fully-equipped cabinet.
NCS 1001-K9 shall be installed maintaining a minimum clearance of 5mm above and below the chassis.
Before You Begin
Ensure the rack is compatible. See the Rack Comatibility section.
10

Cisco NCS 1001 Specifications

General

Brand	Cisco
Model	NCS 1001
Category	Network Hardware
Language	English