Cisco Network Device Cisco 2800 User Manual

Corporate Headquarters:
Copyright © 2004 Cisco Systems, Inc. All rights reserved.
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Preinstallation Requirements and Planning for
Cisco 2800 Series Routers
This document describes site requirements and equipment needed to install your Cisco 2800 series
integrated services router. It includes the following sections:
• Safety Recommendations, page 1
• General Site Requirements, page 3
• Installation Checklist, page 6
• Creating a Site Log, page 7
• Inspecting the Router, page 7
• Required Tools and Equipment for Installation and Maintenance, page 8
Note To see translations of the warnings that appear in this publication, refer to the Cisco 2800 and Cisco
3800 Series Integrated Services Routers Regulatory Compliance and Safety Information document that
accompanies your router.
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Safety Recommendations
Follow these guidelines to ensure general safety:
• Keep the chassis area clear and dust-free during and after installation.
• If you remove the chassis cover, put it in a safe place.
• Keep tools and chassis components away from walk areas.
• Do not wear loose clothing that could get caught in the chassis. Fasten your tie or scarf and roll up
your sleeves.

Cisco Network Device Cisco 2800 Specifications

General

Product Type	Router
Connectivity Technology	Wired
Data Link Protocol	Ethernet, Fast Ethernet, Gigabit Ethernet
Power Source	AC power supply
Humidity Range Operating	10% to 85% non-condensing
Product Series	Cisco 2800
Network/Transport Protocol	IP
Remote Management Protocol	SNMP, HTTP, HTTPS, Telnet
Features	Firewall protection, VPN support, Quality of Service (QoS)
Operating Temperature	0 to 40 °C
WAN Interface	T1/E1, Serial
Routing Protocols	BGP, OSPF, EIGRP, RIP
Security Features	Firewall, VPN
Total Number of Ports	Varies by model