Cisco Nexus 3000 series Hardware Installation Guide

CHAPTER 4
Connecting the Switch to the Network
• Preparing for Network Connections, on page 53
• Connecting to a Console, on page 53
• Connecting the Management Interface, on page 54
• Connecting Interface Ports to Other Devices, on page 54
• Maintaining Transceivers and Optical Cables, on page 57
Preparing for Network Connections
When preparing your site for network connections to your switch, consider the following for each type of
interface and gather all the required equipment before connecting the ports:
• Cabling required for each interface type
• Distance limitations for each signal type
• Additional interface equipment required
Connecting to a Console
You can connect the switch to a console to perform the following functions:
• Configuring the switch using the CLI
• Monitoring network statistics and errors
• Configuring SNMP agent parameters
• Downloading software updates
We recommend that you use this port to create a local management connection to set the IP address and other
initial configuration settings before connecting the switch to the network for the first time.
Note
The console port on the switch is an RS-232 port with an RJ-45 interface. This is an asynchronous (async)
serial port; any device connected to this port must be capable of asynchronous transmission.
Cisco Nexus 3000 Series Hardware Installation Guide
53

Cisco Nexus 3000 series Specifications

General

Category	Switch
Latency	Sub-microsecond
Typical Power Consumption	Varies by model
Layer	L2/L3
Management	CLI, SNMP
Port Density	Varies by model
Forwarding Capacity	Up to 2.4 Bpps