• C-NIM-2T
From Cisco IOS XE Dublin 17.12.1a, only C1100TGX-1N24P32A SKU of the
Cisco 1100 Terminal Services Gateway supports C-NIM-2T.
Note
• NIM-VAB-A
From Cisco IOS XE 17.14.1a, NIM-VAB-A is supported on the Cisco 1100
Terminal Services Gateway.
Note
Avoid using or servicing any equipment that has outdoor connections during an electrical storm. There may
be a risk of electric shock from lightning. Statement 1088
Warning
Hazardous network voltages may be present in interface ports regardless of whether power to the unit is OFF
or ON. To avoid electric shock, before servicing, disconnect cables from the following ports: NIM-LTEA-EA,
NIM-LTEA-LA Statement 1026
Warning
To reduce the risk of electric shock, the shield of the coaxial cable must be connected to the building earth.
Statement 1253
Warning
To reduce the risk of electric shock, refer to national and local codes for proper installation and grounding of
antennas. Statement 1052
Warning
Installing and Removing a NIM
To install a NIM, perform these steps:
• Locate the NIM slot on the front panel.
• Loosen the screws to open the NIM blank cover.
• Insert the NIM into the slot.
• Tighten the screws to secure the NIM in the slot.
To remove a NIM, perform these steps:
• If the NIM is up and running, shut down the NIM gracefully before removing it.
Install and Remove Small Form-Factor Pluggable Modules and Field Replaceable Units
2
Install and Remove Small Form-Factor Pluggable Modules and Field Replaceable Units
Installing and Removing a NIM
To Next Page
Loading...
Need help?
General
