Cisco RV345/RV345P Router Quick Start Guide 5
NOTE For the RV345 and RV345P, LEDs are built into the magnetic jacks
for the LAN and WAN Ethernet ports. The left is the LINK/ACT and the
right is GIGABIT.
Back Panel
POWER—Toggles power to the device on or off.
12VDC (2.5A) or 54VDC (2.78A)—Power port that connects the device to
the provided 12VDC, 2.5 or 54VDC 2.78 amp power adapter.
Console Port—The router console port is designed for a serial cable
connection to a terminal or a computer that is running a terminal emulation
program.
Side Panel
USB 2—Type A USB port that supports flash drives and 3G/4G/LTE USB
dongles. Caution: Use only the power supply provided with the device;
using other power supplies may cause the USB dongle to fail.
Kensington Lock Slot - Lock slot on the right side to secure the device
physically, using the Kensington lock-down equipment.
USB 1 and USB 2 Off when no USB device is connected, or is
inserted but not recognized.
Solid green when the USB dongle is connected
to the ISP successfully. (IP address has been
assigned); USB storage is recognized.
Flashing green when sending or receiving data.
Solid amber when the USB dongle is recognized
but fails to connect to ISP (no IP address is
assigned). The USB storage access has errors.
Reset
• To reboot the router, press the reset button
with a paper clip or pen tip for less than 10
seconds.
• To reset the router to factory default settings,
press and hold the reset button for 10
seconds.
To Next Page
Loading...
Need help?
General
