Quality of Service
General
424 Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
23
Bandwidth
The Bandwidth page displays bandwidth information for each interface.
To view the bandwidth information:
STEP 1 Click Quality of Service > General > Bandwidth.
The fields in this page are described in the Edit page below, except for the following fields:
• Ingress Rate Limit:
- Status—Displays whether Ingress Rate Limit is enabled.
- Rate Limit (KBits/sec)— Displays the ingress rate limit for the port.
- %— Displays the ingress rate limit for the port divided by the total port bandwidth.
- CBS (Bytes)—Maximum burst size of data for the ingress interface in bytes of data.
• Egress Shaping Rates:
- Status—Displays whether Egress Shaping Rates is enabled.
- CIR (KBits/sec)—Displays the maximum bandwidth for the egress interface.
- CBS (Bytes)—Maximum burst size of data for the egress interface in bytes of data.
STEP 2 Select an interface, and click Edit.
STEP 3 Select the Port or LAG interface.
STEP 4 Enter the fields for the selected interface:
• Ingress Rate Limit—Select to enable the ingress rate limit, which is defined in the field
below. (Not relevant for LAGs)
• Ingress Rate Limit (Kbits per sec)—Enter the maximum amount of bandwidth
allowed on the interface. (Not relevant for LAGs)
• Ingress Committed Burst Size (CBS)—Enter the maximum burst size of data for the
ingress interface in bytes of data. This amount can be sent even if it temporarily
increases the bandwidth beyond the allowed limit. This field is only available if the
interface is a port. (Not relevant for LAGs)
• Egress Shaping Rate—Select to enable egress shaping on the interface.
• Committed Information Rate (CIR)—Enter the maximum bandwidth for the egress
interface.
To Next Page
Loading...
Need help?
General
