SNMP
Communities
Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x 370
21
To define SNMP communities:
STEP 1 Click SNMP > Communities.
This page contains a table of configured SNMP communities and their properties. The fields in
this page are described in the Add page except for the following field:
• Community Type—Displays the mode of the community (Basic or Advanced).
STEP 2 Click Add.
This page enables network managers to define and configure new SNMP communities.
STEP 3 SNMP Management Station—Click User Defined to enter the management station IP
address that can access the SNMP community. Click All to indicate that any IP device can
access the SNMP community.
• IP Version—Select either IPv4 or IPv6.
• IPv6 Address Type—Select the supported IPv6 address type if IPv6 is used. The
options are:
- Link Local—The IPv6 address uniquely identifies hosts on a single network link. A
link local address has a prefix of FE80, is not routable, and can be used for
communication on the local network only. Only one link local address is supported.
If a link local address exists on the interface, this entry replaces the address in the
configuration.
- Global—The IPv6 address is a global Unicast IPV6 type that is visible and
reachable from other networks.
• Link Local Interface—If the IPv6 address type is Link Local, select whether it is
received through a VLAN or ISATAP.
• IP Address—Enter the SNMP management station IP address.
• Community String—Enter the community name used to authenticate the management
station to the device.
• (Community Type) Basic—In this community type, there is no connection to any
group. You can only choose the community access level (Read Only, Read Write, or
SNMP Admin) and, optionally, further qualify it for a specific view. By default, it
applies to the entire MIB. If this is selected, enter the following fields:
- Access Mode—Select the access rights of the community. The options are:
Read Only—Management access is restricted to read-only. Changes cannot be made
to the community.
To Next Page
Loading...
Need help?
General
