EasyManuals Logo
Home>Cisco>Server>UCS B200 M4

Cisco UCS B200 M4 User Manual

Cisco UCS B200 M4
46 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
DescriptionColorLED
Can mean either no fault detected or the drive is not
installed.
OffHealth
(Disk Drive)
Rebuild drive active. If the Activity LED is also flashing
green, a drive rebuild is in progress.
Flashing Amber
4 hz
Fault detected.Amber
Buttons
The Reset button is recessed in the front panel of the server. You can press the button with the tip of a paper
clip or a similar item. Hold the button down for five seconds, and then release it to restart the server if other
methods of restarting do not work.
The locator function for an individual server may get turned on or off by pressing the locator button/LED.
The power button allows you to manually take a server temporarily out of service but leave it in a state where
it can be restarted quickly. If the desired power state for a service profile associated with a blade server is set
to "off," using the power button or Cisco UCS Manager to reset the server will cause the desired power state
of the server to become out of sync with the actual power state and the server may unexpectedly shut down
at a later time. To safely reboot a server from a power-down state, use the Boot Server action in Cisco UCS
Manager.
Local Console Connector
The local console connector allows a direct connection to a blade server to allow operating system installation
and other management tasks to be done directly rather than remotely. The port uses the KVM dongle cable
that provides a connection into a Cisco UCS blade server; it has a DB9 serial connector, a VGA connector
for a monitor, and dual USB ports for a keyboard and mouse. With this cable, you can create a direct connection
to the operating system and the BIOS running on a blade server. A KVM cable ships standard with each blade
chassis accessory kit.
Figure 2: KVM Cable for Blade Servers
Cisco UCS B200 M4 Blade Server Installation and Service Note
4
Overview
Buttons

Other manuals for Cisco UCS B200 M4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco UCS B200 M4 and is the answer not in the manual?

Cisco UCS B200 M4 Specifications

General IconGeneral
Tcase72.1 °C
Bus typeQPI
SteppingR2
FSB ParityNo
Scalability2S
Processor codeSR206
Processor cache20 MB
Processor cores8
Processor modelE5-2630V3
System bus rate8 GT/s
Processor seriesIntel Xeon E5-2600 v3
Processor socketLGA 2011-v3
Processor threads16
Processor codenameHaswell
Motherboard chipsetIntel C610
Processor frequency2.4 GHz
Processor cache typeSmart Cache
Processor lithography22 nm
Processor manufacturerIntel
Processor package size52.5 x 45 mm
Processor front side bus- MHz
Processor boost frequency3.2 GHz
Processor operating modes64-bit
ECC supported by processorYes
Supported instruction setsAVX
Thermal Design Power (TDP)85 W
Compatible processor seriesIntel® Xeon®
Supported processor socketsLGA 2011-v3 (Socket R)
Number of processors installed2
Maximum number of PCI Express lanes40
Memory types supported by processorDDR4-SDRAM
Memory channels supported by processorQuad
Memory clock speeds supported by processor1600, 1866 MHz
Memory bandwidth supported by processor (max)59 GB/s
Maximum internal memory supported by processor768 GB
Memory slots24x DIMM
Internal memory- GB
Memory clock speed2400 MHz
Number of DIMM slots24
Supported DIMM module capacities64GB
USB 2.0 ports quantity0
Ethernet LAN (RJ-45) ports-
Power supply- W
SafetyUL 60950-1 No. 21CFR1040 Second Edition, CAN/CSA-C22.2 No. 60950-1 Second Edition, IEC 60950-1 Second Edition, EN 60950-1 Second Edition, IEC 60950-1 Second Edition, AS/NZS 60950-1, GB4943 2001
Operating altitude0 - 3000 m
Non-operating altitude0 - 12000 m
Storage temperature (T-T)-40 - 65 °C
Operating temperature (T-T)10 - 35 °C
Storage relative humidity (H-H)5 - 93 %
Ethernet interface type40 Gigabit Ethernet
RAID levels0, 1
HDD interfaceSATA
Storage controllerLSI SAS3108
Total storage capacity0 GB
Compatible memory cardsSD
Maximum storage capacity3.2 TB
Storage drive sizes supported2.5 \
Supported storage drive typesHDD & SSD
Supported storage drive interfacesPCI Express, Serial ATA
PCI Express slots version3.0
Intel® Virtualization Technology (Intel® VT)VT-d, VT-x
Heat sinkUCSB-HS-EP-M4-F=, UCSB-HS-EP-M4-R=, UCSX-HSCK=
Chassis typeRack
Cooling typeActive
Product colorGray
LED indicatorsNetwork, Power
Number of fans8 fan(s)
Processor ARK ID83356
Intel Secure Key Technology version1.00
PC health monitoringLED
Sustainability certificatesNetwork Equipment Building Standards (NEBS)
Weight and Dimensions IconWeight and Dimensions
Depth620 mm
Width203 mm
Height50 mm

Related product manuals