Cisco UCS C200 Setup

Set up CIMC for UCS C−Series Server
Document ID: 111455
Contents
Introduction
Prerequisites
Requirements
Components Used
Network Diagram
Conventions
Background Information
Getting CIMC Started
Initial Setup
KVM Features
Cable Connections
Power Up the KVM
Power UP KVM View
F8 to configure/view CIMC IP
Access CIMC
Verify
Troubleshoot
Related Information
Introduction
This support document provides an overview for the steps required to set up CIMC network connectivity for
the UCS C−Series server.
Prerequisites
Requirements
Cisco recommends that you:
Have a working knowledge of the Cisco UCS C−Series Server Blade hardware and software
administration.
•
Be familiar with UCS C−Series Servers Cisco Integrated Management Controller•
Understand the impact and implications of the different commands described in this document.•
Be familiar with the UCS C−Series components and topology.•
Components Used
The information in this document is based on Cisco UCS C−Series Servers.
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a default configuration. If your network is live, make sure that you
understand the potential impact of any command.

Cisco UCS C200 Specifications

General

Brand	Cisco
Model	UCS C200
Category	Server
Language	English