Cisco UCS C22 M3 Upgrade Guide

9
Cisco UCS C-Series Servers Upgrade Guide for Intel E5-2600 v2/E5-2400 v2 Series CPUs
OL-28629-01
Downgrading Cisco UCS C-Series Servers From Intel E5-2600/E5-2400 v2 Series CPUs
Downgrade Scenario 2: Standalone Server
This scenario assumes the following conditions:
• The C-Series server is in standalone mode.
• The Cisco UCS Manager software is at the minimum version or later (seeMinimum Software and
Firmware Requirements, page 2).
• The C-Series server is using the BIOS/CIMC minimum version or later (seeMinimum Software and
Firmware Requirements, page 2).
• The C-Series server is using the Intel E5-2600/E5-2400 v2 Series CPUs.
Use the following procedure to downgrade to earlier supported CPUs.
Step 1 Power off the server.
Step 2 Replace the Intel E5-2600/E5-2400 v2 Series CPUs with the earlier supported CPUs.
Use the CPU replacement procedures in the Installation and Service guide for your server: Cisco UCS
C-Series Installation and Upgrade Guides.
Step 3 Power on the server.
Note The CIMC bundle, including the server CIMC and BIOS, is backward-compatible with earlier
supported CPUs, so the following firmware downgrade steps are optional.
Step 4 Optional: Downgrade your server CIMC.
Use the CIMC firmware management procedures in the GUI or CLI Integrated Management Controller
Configuration Guide for your release.
Step 5 Optional: Downgrade your server BIOS.
Use the CIMC firmware management procedures in the GUI or CLI Integrated Management Controller
Configuration Guide for your release.
.

Cisco UCS C22 M3 Specifications

General

Brand	Cisco
Model	UCS C22 M3
Category	Server
Language	English