EasyManuals Logo
Home>Cisco>Server>UCS C220 M4

Cisco UCS C220 M4 Upgrade Guide

Cisco UCS C220 M4
10 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
4
Cisco UCS C-Series Servers Upgrade Guide for Intel Xeon v3 Series CPUs
Minimum Software and Firmware Requirements
Upgrading to Intel Xeon v3 Series CPUs
Note These upgrade procedures require server downtime.
This section contains the following topics:
Upgrade Scenario 1: UCSM-Managed C-Series Server, page 4
Upgrade Scenario 2: Standalone Server, page 5
Upgrade Scenario 3: Standalone Server RMA; BIOS on Spare Server is Earlier Than the Minimum
Version, page 6
Upgrade Scenario 1: UCSM-Managed C-Series Server
This scenario assumes the following conditions:
The server is managed by Cisco UCS Manager.
The Cisco UCS Manager software is earlier than the minimum (see Minimum Software and
Firmware Requirements, page 2).
The C server is at a BIOS/Cisco IMC version earlier than the minimum (see Minimum Software and
Firmware Requirements, page 2).
The server is using CPUs earlier than Intel Xeon v3 Series.
The server is using DDR3 memory risers and DIMMs.
In this case, use the following procedure to upgrade the server, CPUs, memory risers, and DIMMs.
Step 1 Upgrade the Cisco UCS Manager software to the minimum version for your server (or later). See
Table 1.
Use the procedures in the appropriate Cisco UCS Manager upgrade guide (depending on your current
software version): Cisco UCS Manager Upgrade Guides.
Step 2 Use Cisco UCS Manager to upgrade and activate the server Cisco IMC to the minimum version for your
server (or later). See Table 1.
Use the procedures in the GUI or CLI Cisco UCS Manager Firmware Management Guide for your
release.
Note If you use a method other than Cisco UCS Manager to update the integrated server’s Cisco IMC
firmware, you must also manually initiate a low-level firmware upgrade. See Low-Level Firmware
Requirements, page 2.
Step 3 Use Cisco UCS Manager to upgrade and activate the server BIOS to the minimum version for your server
(or later). See Table 1.
Use the procedures in the Cisco UCS Manager GUI or CLI Cisco UCS Manager Firmware Management
Guide for your release.
Step 4 Decommission and then power off the server.
Step 5 Replace the CPUs with the Intel Xeon v3 Series CPUs.
Use the CPU replacement procedures in the Installation and Service guide for your server: Cisco UCS
C-Series Installation and Upgrade Guides.

Other manuals for Cisco UCS C220 M4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco UCS C220 M4 and is the answer not in the manual?

Cisco UCS C220 M4 Specifications

General IconGeneral
Tcase78.9 °C
Bus typeQPI
SteppingM1
FSB ParityNo
Scalability2S
Processor codeSR1YA
Processor cache25 MB
Processor cores10
System bus rate9.6 GT/s
Processor seriesIntel Xeon E5-2600 v3
Processor socketLGA 2011-v3
Processor threads20
Processor codenameHaswell
Motherboard chipsetIntel C610
Processor frequency2.3 GHz
Processor cache typeSmart Cache
Processor lithography22 nm
Processor manufacturerIntel
Processor package size52.5 x 45 mm
Processor front side bus- MHz
Processor boost frequency3 GHz
Processor operating modes64-bit
ECC supported by processorYes
PCI Express configurationsx4, x8, x16
Supported instruction setsAVX 2.0
Thermal Design Power (TDP)105 W
Compatible processor seriesIntel® Xeon®
Supported processor socketsLGA 2011-v3 (Socket R)
Number of processors installed2
Physical Address Extension (PAE)46 bit
Maximum number of PCI Express lanes40
Memory types supported by processorDDR4-SDRAM
Memory channels supported by processorQuad
Memory clock speeds supported by processor1600, 1866, 2133 MHz
Memory bandwidth supported by processor (max)68 GB/s
Maximum internal memory supported by processor768 GB
HDD size- \
RAID levels0, 1, 5, 6, 10, 50, 60, JBOD
HDD interface-
Total storage capacity0 GB
Maximum storage capacity- TB
Number of HDDs installed0
Memory slots24
Internal memory16 GB
Memory clock speed2133 MHz
Maximum internal memory384 GB
Maximum graphics card memory8 MB
Graphics cardG200e
Graphics card familyMatrox
Intel® Virtualization Technology (Intel® VT)VT-d, VT-x
Cabling technology10/100/1000Base-T(X)
Ethernet interface typeGigabit Ethernet
USB 2.0 ports quantityUSB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Ethernet LAN (RJ-45) ports4
PCI Express slots version3.0
Processor ARK ID81705
Intel Secure Key Technology version1.00
Intel Identity Protection Technology version0.00
Power supply770 W
Power supply input frequency50 - 60 Hz
Chassis typeRack (1U)
Trusted Platform Module (TPM) version1.2
Compatible operating systemsMicrosoft Windows Server 2012 R2 Microsoft Windows Server 2012 Microsoft Windows Server 2008 R2 Red Hat Enterprise Linux Novell SUSE Linux Enterprise Server Oracle Linux (Unbreakable Enterprise Kernel (UEK)) Oracle Solaris Ubuntu Server CentOS
Weight and Dimensions IconWeight and Dimensions
Depth756 mm
Width430 mm
Height43.2 mm

Related product manuals