2 Cisco WAP351 Quick Start Guide
Welcome
Thank you for choosing the Cisco WAP351 Wireless-N Dual Radio Access
Point with 5 Ports Switch. The Cisco WAP351 is an indoor concurrent
dual-band radio 802.11n access point with integrated PoE switch.
This guide provides the general layout of the Cisco WAP351, describe
how to deploy the Cisco WAP351 in your network, and describe how to
configure the Cisco WAP351. For additional information, see
www.cisco.com/go/300_wap_resources.
Before You Begin
Before you begin the installation, make sure that you have the following
equipment and services:
• A computer with browser support for:
– Internet Explorer 7.0 or later
– Chrome 5.0 or later
– Firefox 3.0 or later
– Safari 3.0 or later
• Tools for installing the hardware
• One or more Ethernet network switches with PoE
Cisco WAP351 Features
Front Panel
The front panel of the Cisco WAP351 consists of three lights: Power,
WLAN, and PSE. For full descriptions of the colors of the lights and their
indications, see “Verifying the Hardware Installation”.
Back Panel
POWER—The POWER button is used to turn the power on and off. It is not
applicable when using PoE.
48V DC—The 48V DC jack is used to connect the power adapter to the
Cisco WAP351 if you are not using PoE.
RESET—See “Rebooting the Cisco WAP351 or Resetting to Factory
Defaults” for information on the RESET button.
To Next Page
Loading...
Need help?
General
