2. Preparations before Operation
Remove the back cover of the remote controller according to
the arrow direction.
Fill in two AAA size 1.5V batteries after confirming the porlarities.
Reinstall the back cover.
1.
2.
3.
3. Operation Contents Setting
3-1 Illustration of Indicating Lamps
9
1.
2.
3.
4.
5.
There may be difference between the temperature set by the remote controller (The air
conditioner will stop working while cooling or heating reach this temperature) and measured
by temperature measuring device. You can regulate the temperature you want only by the
remote controller.
It is not certain that the room temperature can reach the temperature displayed on the remote
controller. Only when the room area is proper, the heat preservation is very good, etc ., can they
match each other. So, the temperature set by the remote controller and the temperature the
room can get are two different concepts.
The displaying temperature on the remote controller is the set temperature.
The speed of indoor fan has three grades: high speed grade, low speed grade and breeze
grade (the breeze grade can’t be controlled by man but by microcomputer automatically). The
remote controller transmit “mid-speed” signal,main frame will dispose it as low speed
automatically.
The remote controller should be aimed at the receiving window of the main frame which will
send out a “du” sound when the signal is received.
2-1 Usage of Batteries
Aim the signal transmitting tube to the signal receiving window of the indoor unit.
There should be nothing between the remote controller and the signal receiving window.
Avoid violent bumping.
Avoid direct sunshine, heater and other heat resources.
The remote controller should be kept clean and dry.
Please adopt two AAA size 1.5V batteries with same brand.
The batteries should be taken out if the unit won’t be used for a long period of time.
Change another two new batteries if the relative contents can’t be displayed clearly on the
LCD of the remote controller or the distance of controlling turns short obviously.
Never mix the new battery with the old one.
2-2 Operation of the Remote Controller
Running lamp (green):on: The conditions satisfy the compressor to work.
flash: The unit is in the anti cold wind state of defoosting state.
out: The compressor does not work.
Timer lamp (yellow)on: Indicate the air conditioner is timed to on or off.
Protection lamp (red) flash: Indicate the air conditioner is abnomal, please notify the serviceman.
To Next Page
Loading...
Need help?
General