Arion 500-600 10.07 –
GB
A.12
Transporting or lifting persons using the frontal loader is strictly forbidden.
Limit any movement with a raised load. The tractor may become unbalanced.
Never leave the tractor with a raised load.
OPERATION
GENERAL RULE
As a general rule, always use equipment in good condition, suitable for the size of the tractor and the type of work.
The load permitted on the axle must not exceed the load specified by the manufacturer of the tractor. Contact your approved
CLAAS repair agent.
Loader
Use the CLAAS frontal loader without the additional weights of the tractor (they may interfere with the movement).
Each tool has been designed for a specific use and has its own resistance limits.
Land clearing and stump removal are forbidden. They are not within the scope of the CLAAS frontal loader.
WHEEL TRACK
P.
Always use the maximum track compatible with the work in hand, to reduce the risks of overturning.
ATTACHING IMPLEMENTS
Pour at t
To hitch or unhitch an implement, place the gear lever in neutral
and apply the hand brake. Use a low gear for all tractor
manoeuvres.
Si
Sufficient front-end ballast must be used if the implement is
heavy, to prevent the tractor rearing-up.
Barre à t rous o
Drawbar: This is not intended as a trailer towing hitch and is not
designed to carry vertical loads.
Pour l 'at
Use the safety equipment provided to hitch implements (towing
jaw, towing stub, retaining pins, etc.).
L
During hitching operations or when using the external linkage
control, the operator must remain outside the hitch frame.
L
The eye bolt on the front ballast weights must only be used for
towing the tractor in conjunction with a towbar and over firm
ground. Under no circumstances is it to be used for towing a
tool or a bogged down tractor.
001hsn36
To Next Page
Loading...
Need help?
General
