Arion 500-600 10.07 –
GB
A.13
Driving
Do not enter or leave the tractor when it is in motion. Avoid risk of overturning.
Do not turn sharply when working on slopes. Maximum slope allowed while working: See chapter
K
.
During a break in work, even if only brief, stop the engine and apply the handbrake. If the ground slopes, engage a gear. Lower
the implement to the ground.
Loader
The use of controls that set the frontal loader in motion when the driver is not controlling the lever is forbidden and will place the
equipment outside standard limits.
Use the motivity of the tractor to penetrate into the material rather than momentum which subjects the frontal loader and the
tractor to substantial constraints.
Do not stress the hydraulic elements when the load is too substantial and when the jacks are at the end of their stroke.
Note: Work with flexibility and wisely.
Control the frontal loader from the driver's seat only.
Do not leave the seat without having first ensured that no movement of the controls will occur.
Remove any person from the frontal loader's area of operation.
Pay attention to electrical and overhead power lines when manoeuvring the frontal loader in raised position.
After using the frontal loader, park the tractor with the frontal loader lowered to the ground.
STATIONARY WORK
If the tractor has to work in a fixed position (use of static implements), chock the tractor wheels, apply the hand brake and keep
a constant watch on it.
USE OF TOOLS DRIVEN BY THE PTO
É
Do not wear loose clothing which could catch in moving parts.
P
The engine must be stopped before coupling or uncoupling the
attachment's universal joint shaft.
Au trava
All guards must be fitted when working.
E
When repairing, adjusting or lubricating an attachment in the
field, always set the PTO lever to neutral and stop the engine.
L
When the PTO is not in use, set the lever to neutral (shaft
stationary) and fit the protection cover.
001hsn37
To Next Page
Loading...
Need help?
General
