Operation/Installation Manual
7
Mixed-Mode Satellite and Subwoofer System
(Set INPUT SELECT Switch to STEREO)
Subwoofer 4 Ohms
Figure 6
The amplifier can be configured for a mixed-mode operation. The table provides
component values to create a 6dB per octave crossover at specified frequencies.
Use components that have a + 5% tolerance and capacitors rated at 100V.
NOTE: Choose the same frequency for both LP and HP crossovers. Do not over-
lap frequencies, as this may damage the amplifier.
FREQ (Hz)
80
100
125
150
200
L (mH)
8.0
6.4
5.1
4.2
3.2
C (µF)
497
398
318
265
199
NOTE: Chart values based on
4 Ohm speakers.
To Next Page
Loading...
Need help?
General
