English
31 CX201
8. ERROR DISPLAYS
If an error occurs, one of the following displays is displayed.
Take the measures described below to eliminate the problem.
If an error display other than the ones described above appears, press the reset button. If the problem
persists, turn off the power and consult your store of purchase.
Error Display Cause Measure
CD/MP3/WMA
ERROR 2 A CD is caught inside the CD
deck and is not ejected.
This is a failure of CD deck’s mechanism and consult
your store of purchase.
ERROR 3 A CD cannot be played due
to scratches, etc.
Replace with a non-scratched, non-warped-disc.
ERROR 6 A CD is loaded upside-down
inside the CD deck and does
not play.
Eject the disc then reload it properly.
USB/iPod
ERROR 7 (iPod
mode)
The connected iPod is not
recognized.
Disconnect and reconnect the iPod.
ERROR 7 Overcurrent detection. Disconnect the devices and reconnect. If the devices
are still not recognized, try replacing with a different
devices.
ERROR 7 Do not support the HUB
devices.
Do not use the HUB devices.
CX201_EN.book Page 31 Wednesday, November 17, 2010 10:50 AM
To Next Page
Loading...
Need help?
General
