280-8303-00
DB265MP 17
English
9. TROUBLESHOOTING
Power does not turn
on. (No sound is
produced)
Compact disc cannot
be loaded.
Sound skips or is
noisy.
Sound is bad directly
after power is turned
on.
Nothing happens
when button are
pressed. Display is
not accurate.
Problem
Fuse is blown.
Incorrect wiring.
Another compact disc is
already loaded.
Compact disc is dirty.
Compact disc is heavily
scratched or warped.
Water droplets may form on
the internal lens when the
car is parked in a humid
place.
The microprocessor has
malfunctioned due to noise,
etc.
DCP or main unit connectors
are dirty.
Replace with a fuse of the same amperage. If the
fuse blows again, consult your store of purchase.
Consult your store of purchase.
Eject the compact disc before loading the new one.
Clean the compact disc with a soft cloth.
Replace with a compact disc with no scratches.
Let dry for about 1 hour with the power on.
Turn off the power, then press
the [RELEASE] button and
remove the DCP. Press the
reset button for about 2
seconds with a thin rod.
Wipe the dirt off with a soft cloth moistened with
cleaning alcohol.
Cause Solution
Reset button
10. ERROR DISPLAYS
■ To protect the system, this unit has been equipped with self diagnostic functions. If a fault arises, a
warning is issued by various error displays. Follow the corrective measures and remove the fault.
Error Display
ERROR 2
ERROR 3
ERROR 6
This error display indicates that a fault has arisen in the
mechanism of the source unit (for example, the disc cannot
be ejected).
➜ Check the source unit.
This error display indicates that the pickup focus is off
because of a scratched disc or some other factor during
source unit play.
➜ Check the compact disc.
This indicates that the CD’s TOC (table of contents) cannot
be read, for example because the selected disc is upside-
down.
Corrective Measure
To Next Page
Loading...
Need help?
General
