English
9 M109
Inserting the Battery
1 Slide remote control unit’s rear cover in the
direction shown.
2 Insert battery (CR2025) into insertion guides
with printed side (+) up.
3 Press battery into compartment as shown.
4 Replace and slide cover until it clicks into
place.
Notes:
Misuse may result in battery rupture and fluid
leakage, resulting in personal injury or damage.
Always follow these safety precautions:
• Use only the designated battery.
• When replacing the battery, insert with +/–
polarities correctly oriented.
• Do not subject battery to heat, or dispose in fire
or water. Do not attempt to disassemble the
battery.
• Dispose of used batteries properly.
Note:
• Refer to the diagrams in “3. CONTROLS”
(page 6) when reading this chapter.
Basic Operations
CAUTION
Be sure to lower the volume before
switching off the unit power. The unit
remembers its last volume setting.
Turning power on/off
1. Press the [SRC] button to turn on power.
2. Press and hold the [SRC] button (1 sec.) to
turn off power.
Selecting modes
1. Press the [SRC] button to change operation
mode.
2. Each time the [SRC] button is pressed, the
operation mode changes as follows:
Radio ➜ CD/MP3/WMA ➜ AUX ➜ Radio...
Adjusting the volume
1. Turn the [ROTARY] knob clockwise to
increase volume; turn counterclockwise to
decrease volume.
∗ Volume range is 0 (minimum) to 33 (maximum).
Switching the display
Press the [DISP] button to select desired
display.
C
R
2
0
2
5
Insertion guide
6. OPERATIONS
01_M109_EN.book Page 9 Thursday, February 19, 2009 10:43 AM
To Next Page
Loading...
Need help?
General
