5
PREPERATION
CONNECTING THE MULTI HOSE ADAPTOR
1.
Fit the elbow adaptor to the
pump outlet as shown in the
diagram opposite.
2. Screw the multi hose adaptor
onto the elbow.
• The multi hose adaptor is
ca
pable of accepting 1”,
¾”and ½” hoses.
3.
Simply cut the multi hose
connector to the required size
and attach a suitable hose using
with a worm drive clip.
• For maximum efficiency, we
strongly recommend that you
connect a 1½” diameter hose
to the multi hose adapter.
• Alternatively, you may remove
the multi adapter altogether,
and screw on a 1½” BSP hose adapter.
The pump is completely submersible and should be placed in a vertical
position on a solid flat surface, placing the pump on a couple of house bricks if
required.
SUITABLE HOSES AND SPARE/REPLACEMENT MULTI HOSE ADAPTERS ARE
AVAILABLE FROM YOUR CLARKE DEALER.
WARNING: DISCONNECT THE PUMP FROM THE MAINS POWER SUPPLY
BEFORE CONNECTING THE MULTI HOSE ADAPTOR.
To Next Page
Loading...
Need help?
General
