X. SOLVENT, FILTERS AND REPLACEMENT PARTS
Solvent - 5 gallon Type II-A
MIL-PRF-680 Type II specification solvent in a 5-gallon pail.
Solvent - 15 gallon Type II-A
MIL-PRF-680 Type II specification solvent in a 15-gallon pail.
Solvent - 55 gallon Type II-A
MIL-PRF-680 Type II specification solvent in a 55-gallon drum.
Solvent - 5 gallon Type V
MIL-PRF-680 Type IV specification solvent in a 5-gallon pail.
Solvent - 55 gallon Type V
MIL-PRF-680 Type IV specification solvent in a 55-gallon drum.
Solvent - 5 gallon Type II-B
Solvent conforms to MIL-PRF-680 Type II. 5-gallon pail.
Solvent - 55 gallon Type II-B
Solvent conforms to MIL-PRF-680 Type II. 55-gallon drum.
Solvent Tank Filters (case)
0.5 micron filters in a case of four.
Solvent Tank Filter (each)
0.5 micron filters individually.
A gauge telling you when to change the filters
Indicator for solvent levels
A pump for agitating parts in the soak tank.
Control Box for Soak Tank
The electrical control box for the soak tank. Contains switch
and cord.
Grey Plastic Bin for Pre-Clean
Pre-cleaning bin to collect debris.
Pre-Clean Shelf Tray Liner
Lines the pre-clean shelf.
Replacement hose for the air gun.
The optional pump and regulator for use with the air gun.
Includes only the air gun.
Halogen light fixture with attaching bar, fusible link and
halogen bulb.
Valve to turn on/off nozzle
The pump that circulates the solvent through filtration.
The red solvent hose, 1/2"
The red solvent hose, 3/8"
Plastic plugs (specify size)
Switch (for light/soak pump)
The switch for the light and soak tank (option)
Main Switch (gr push button)
The green, ON push button.
Fuse Holders (rectangular
grey)
Fuse holder for current models. Rectangular grey plastic holder,
located inside electrical box.
Clamps solvent hose to brush.
Fuse Holder (round black)
Fuse holder for older machines. Round black holder, located on
outside of electrical box.
Metal screen for the drain.
The hand pump for draining the sludge.
Replacement Solvent Brush
Replacement Solvent Brush
Yellow brush hose, 4' long
Lid O-Ring Viton - Filter
Canister
Filter canister lid o-ring
Contact block for the two-position switch.
The clip that holds the lid open.
The filter pressure gauge