Cleanmaxx CP-CY4207EP-7 User Manual

25
3. Hold the dust container by its handle over a dustbin. Press the
fastener on the dust container and remove the dust container
hatch. The dust container can now be emptied.
4. Place the dust container hatch back onto the dust container and
close the hatch. The hatch must be heard to engage in place.
5. Then place the dust container into the device and close the dust
container cover. The cover must be heard to engage in place.
Cleaning the Dust Filter
The dust fi lter sits on the back of the dust container.
It consists of two parts.
1. Pull up the catch to open the dust container cover and fl ip up the cover at the same
time.
2. Pull the dust container up out of the device by its handle.
3. Remove the fi lter from the dust container.
4. Tap the fi lter out over a dustbin. Clean the fi lter using a soft brush if necessary. You
can also rinse the fi lter under clear, lukewarm water. Attention: Do NOT use any
detergent! Allow the fi lter to dry completely.
5. Insert the fi lter back into the dust container:
6. Then place the dust container into the device and close the dust container cover. The
cover must be heard to engage in place.
Cleaning the Motor Filter
The motor fi lter sits behind the dust container in the dust container
compartment.
1. Pull up the catch to open the dust container cover and fl ip up the cover at the same
time.
2. Pull the dust container up out of the device by its handle.
3. Remove the fi lter from the dust container compartment.
4. Tap the fi lter out over a dustbin. Clean the fi lter using a soft brush if necessary. You
can also rinse the fi lter under clear, lukewarm water. Attention: Do NOT use any
detergent! Allow the fi lter to dry completely.
5. Insert the fi lter back into the dust container compartment.

Cleanmaxx CP-CY4207EP-7 Specifications

General

Brand	Cleanmaxx
Model	CP-CY4207EP-7
Category	Vacuum Cleaner
Language	English