Cobra Microtalk Series User Manual

Pull lock tab down
and lift door up
(towards you) to
remove battery
cover.
Insertfour “AAA”
batteries.Position
batteries according
to po l a ri ty marki n g s .
Remove belt clip by (A.) pulling tab out and
(B.) sliding belt clip up and off unit.
Operation
3
Operation
2
Note
Batteries not included with
MicroTalk 2-way radio.
Note
Always use high-quality
alkaline or NiMH batteries.
Incorrect positioning can
damage both the batteries
and the unit.
Only the Cobra NiMH
battery pack (Part no.
PMR-BP) can be
recharged via the desk-
top charger (Part no.
PMR-CH).
See Accessories on page 16.
Charge ports for recharging
NiMH (Nickel Metal
Hydride) battery pack are
located on back of unit.
Note
When batteries are low or
need charging the
BATT LOW indicator will
blink red. Replace alkaline
batteries or recharge NiMH
battery pack.
Install Batteries
Battery
Installation
Clear antenna.
1
2
3 4
A.
B.
PMR100-UK.qx copy 6/17/99 9:36 AM Page 2

Cobra Microtalk Series Specifications

General

Brand	Cobra
Model	Microtalk Series
Category	Two-Way Radio
Language	English