download a corporate image to a hard drive. The NIC option ROM takes up memory space
below 1MB commonly referred to as DOS Compatibility Hole (DCH) space. This space is
limited. This F10 option will allow users to disable the downloading of this embedded NIC option
ROM thus giving more DCH space for additional PCI cards which may need option ROM space.
The default will be to have the NIC option-ROM-enabled.
●
SATA RAID Option ROM Download (enable/disable). The BIOS contains an embedded SATA
RAID option ROM to for RAID support. This can be temporarily disabled to save DCH space.
Note that with the option ROM disabled, users will be unable to use boot to hard drives in the
system while running in RAID mode.
●
HPET (enable/disable). The HPET (high precision event timer) can be disabled in the event
that it causes a resource conflict in the OS.
●
Surround View (enable/disable). This enables the ATI Surround View option that allows the
integrated graphics controller and an ATI PCI Express graphics card to work at the same time
for multi-monitor support.
Recovering the Configuration Settings
This method of recovery requires that you first perform the Save to Removable Media command with
the Computer Setup (F10) Utility before Restore is needed. (See
Save to Removable Media
on page 3 in the Computer Setup—File table.)
NOTE: It is recommended that you save any modified computer configuration settings to a diskette,
a USB flash media device, or a diskette-like device (a storage device set to emulate a diskette drive)
and save the diskette or device for possible future use.
To restore the configuration, insert the diskette, USB flash media device, or other storage media
emulating a diskette with the saved configuration and perform the Restore from Removable Media
command with the Computer Setup (F10) Utility. (See
Restore from Removable Media on page 3 in the
Computer Setup—File table.)
Table 6 Computer Setup—Advanced (for advanced users) (continued)
ENWW Recovering the Configuration Settings 13