1-4 English
Writer: M. Silvetti Saved by: Marianne Silvetti Saved date: 06/24/98 4:36 PM
Pages: 14 Words: 2440 Template: c:\msoffice\templates\working\comm.dot
File Name BCH1_EN.doc Part Number 308012-001
Setting Up the
Monitor
To set up the monitor, ensure that the power is turned off to the
monitor, computer system, and other attached devices, then
follow these steps:
1. Place the monitor in a convenient, well-ventilated location
near your computer.
2. Connect the monitor signal cable 1 to the 15-pin connector
on the rear panel of the computer and tighten the screws.
✎
Be sure the signal cable aligns with the 15-pin connector. Do not
force the cable onto the connector or you may damage the signal
cable.
3. Connect the monitor power cord 2 to the rear panel of the
monitor, then plug the other end into an electrical outlet
that is easily accessible and close to the monitor.
!
WARNING:
To reduce the risk of electric shock or damage to your
equipment, do not disable the power cord grounding feature. This
equipment is designed to be connected to a grounded (earthed)
power outlet that is easily accessible to the operator. The grounding
plug is an important safety feature.
CAUTION:
Be sure that the power outlet you plug your power cord
into is easily accessible and located as close to the monitor as
possible. When you need to disconnect power to the equipment, be
sure to unplug the power cord from the power outlet.
To Next Page
Loading...
Need help?
General
