:::_i:::i/:i:_!i ::_ /:i!_:i; ;_ii ¸ i/ /_ • : : ............
2. Find two pointS and a spur and cup center among the
1o0se parts. To insert point into centers, place center
between jaws of a Vise. Do not tighten vice. Insert point
into center and with a hammer and nail gently tap
around the base of the point until secure,
3. Insert Spur center into head stock spindle and cup
Center into tailstock ram. NOTE: Do no_ drive or
hammer centers into spindle or ram as removal may be
difficult- Use:a soft hammer or block of wood and give
them a gentle tap,
4. To remove spur center from spindle, hold the spindle
pulley with one hand and, Using a wrench or pair of
pliers, turn the hex nut counterclockWise until center
isejected.
5, To remove cup Center insert a 114""wood dowel or brass
rod through the hole in the tailstock ram. Hold the
center with one hand and tap the-dowel or rod with a
hammer,
\
TAILSTOCK
RAM
/
FOOT
WARNING: DON'TCONNECT POWER CORD TO
ELECTRICAL OUTLET IN YOUR SHOP UNTIL
YOU ARE READY TO CHECK MOTOR ROTA-
TION.
ON-OFF SWITCH
The On-Off Switch has a locking feature. THIS FEATURE
IS INTENDED TO PREVENT UNAUTHORIZED AND
POSSIBLE HAZARDOUS USE BY CHILDREN AND
OTHERS,
1. Insert key into switch.
NOTE: Key is made of vetlowplastic.
©
K_Y
(YELLOW _l._ S'{ IC]
KEY
10
To Next Page
Loading...
Need help?
General
