Crown XTi 6000 User Manual

XTi Series Power Ampliers
Operation Manual
操作手册
page 33
XTi 系列功率放大器
Bedienungsanleitung
Leistungsendstufen
Manual de Operación
Amplicadores de potencia
Sensitivity (volts RMS) for full rated power at 4 ohms 1.4V
Frequency Response (at 1 watt into 4 ohms,
20Hz - 20 kHz)
+0/–1 dB
Signal to Noise Ratio (below rated 1 kHz power at 8
ohms), A-weighted 100 dB (103 dB in XTi 6000)
Damping Factor (8 ohm): 20 Hz to 400 Hz
> 500
Input Stage
Input is electronically balanced and employs
pre cision 1% resistors.
AC Line Current (120VAC amplifier playing 1/8 power pink
noise into 4 ohms per ch)
XTi 1000: 6.8A, XTi 2000: 8.3A, XTi 4000: 10.5A;
at idle draws no more than 30 watts.
XTi 6000: 15.3A; at idle draws no more than 180
watts.
Crosstalk (below rated power)
20 Hz to 1 kHz > 70 dB
Input Impedance (nominal) 20 kilohms balanced, 10 kilohms unbalanced
Load impedance (note: safe with all types of
loads)
Stereo
Bridge mono
2-8 ohms (4-8 ohms in XTi 1000 A1 100V versions)
4-16 ohms (8-16 ohms in XTi 1000 A1 100V versions)
Voltage Gain (at 1 kHz, 8 ohm rated output) XTi 1000: 30.5 dB. XTi 2000: 32.9 dB. XTi 4000: 34.2 dB.
XTi 6000: 37.1 dB.
Maximum Input Signal +22 dBu typical
Operating Temperature 0° C to 40° C at 95% relative humidity (non-condensing)
AC Line Voltage and Frequency Configura-
tions Available (± 10%)
100V, 120V, 220-240V 50/60 Hz
Ventilation Flow-through ventilation from front to back
从前到后的直通式通风
Luftstrom von Front zu Rückseite
Ventilación de circulación de flujo del frente hacia atrás
Cooling
Heat sinks and proportional-speed fan
散热器和比例变速风扇
Wärmetauschern und Lüfter mit Proportionaldrehzahl15
Disipadores de calor y ventilador de velocidad proporcional
Dimensions: Width, Height, Depth
(behind mounting surface)
EIA Standard 19 in. W (EIA RS-310-B)
x 3.5 in. (8.9 cm) H x12.25 in. (31.1cm) D
XTi 6000 is 16.2 in. (41.15 cm) D
EIA 标准 19 英寸机架：宽 (EIA RS-310-B)
EIA Standard 19” Breite (EIA RS-310-B)
Estándar EIA 19” de ancho (EIA RS-310-B)
Net Weight, Shipping Weight 18.5 lb (8.4 kg), 21.5 lb (9.8 kg)
XTi 6000 is 24.0 lb (10.9 kg), 30.0 lb (13.6 kg)
6 Specifications 6 规格 6 Technische Daten 6 Especificaciones
Minimum Guaranteed Power, 1 kHz
最低保证功率，1 kHz
Garantierte Mindestleistung, 1 kHz
Potencia Mínima garantizada, 1 kHz
XTi 1000 XTi 2000 XTi 4000 XTi 6000
Per channel, both channels driven
每个声道，同时驱动两个声道
Pro Kanal, beide Kanäle in Betrieb
Por canal, ambos canales operando
Stereo, 2 ohms (per ch.)
Stereo, 4 ohms (per ch.)
Stereo, 8 ohms (per ch.)
Bridge-Mono, 4 ohms
Bridge-Mono, 8 ohms
600W*
†
400W
240W
1200W*
†
800W
975W*
800W
475W
1950W*
1600W
1275W*
1100W
650W
2550W*
2200W
3000W*
2100W
1200W
6000W*
4200W
Rated Power @220 VAC, 1 minute continuous
Stereo, 2 ohms (per ch.)
Stereo, 4 ohms (per ch.)
Stereo, 8 ohms (per ch.)
600W*†
400W
240W
975W*
800W
475W
1275W*
1100W
650W
1100W*
1200W
1000W
With 0.5% THD.
*With 1% THD.
†
Not rated for 100V versions
†

Crown XTi 6000 Specifications

General

Brand	Crown
Model	XTi 6000
Category	Amplifier
Language	English