Cub Cadet 1210 User Manual

LUBRICATION TABLE
Point of Lubrication
Check
at
Hours
Change
at
Hours
Capacity
Anticipated Air Temperature
Above +32®F + 32^ to O^F Below 0®F
Engine crankcase
Check
before
each use
25
4 pints
Cub Cadet Cub Cadet Cub Cadet
Low Ash Low Ash Low Ash
Engine Oil Oil S.A.E. Engine Oil
S.A.E.30 10W-40or S.A.E. 5W-20
10W-30 or5W-30
Hydro-drive unit
mounted on
transmission case
with filter (1210
and 1211
Tractors Only)
30 Add
as needed
Approx.
14 pints
Cub Cadet Hydraulic Transmission Fluid
Note: Cub Cadet hydraulic transmission
fluid meets IH B-6 specifications. If
fluid is used that does not meet these
requirements Cub Cadet will not be
responsible for substandard performance.
Failures due to use of improper fluid are not
covered by warranty. For maximum protection,
use Cub Cadet Hydraulic Transmission Fluid.
Steering knuckles &
front axle pivot bolt
10
Use 251H EP grease or equivalent No. 2 multi¬
purpose lithium grease and apply two or three
strokes or sufficient grease to flush out old
grease and dirt.
Front wheel bearings 100
or
yearly
Remove front wheels and pack bearings with
251H EP grease or equivalent No. 2 multi¬
purpose lithium grease and reinstall wheels.
Steering gear housing
100
or
yearly 1/4 lb
Two strokes of the lubricator using
251H EP grease or equivalent No. 2 multi¬
purpose lithium grease.
Transaxle
(1204 Tractor Only)
100 Add as
needed
4
pints
approx.
CubCadet 135H EP Gear Lubricant.
Right angle gear box
(1204 Tractor Only)
Sealed
unit
Add
as needed
4 ounces
Not serviced! If repairs require disassembly,
gearbox must be refilled with 251H EP or
equivalent No. 2 multi-purpose lithim grease.
LUBRICATION GUIDE
The life of any machine depends upon the care it is
given. Proper lubrication is a very important part of
that care.
Be certain that all lubrication fittings are assembled in
place, using the lubrication illustrations as a guide.
Always lubricate the tractor thoroughly before taking it
to the field. Use a pressure-lubricating gun.
Always force the lubricant through the full length of
each bearing until it emerges at the end, carrying with
it the worn lubricant and any dirt that may have entered
the bearing.
Miscellaneous working parts not provided with
lubrication fittings should be oiled daily with a good
grade of lubricating oil.
Be sure all fittings are free from dirt and paint so the
lubricant is certain to enter the bearing.
30
Lubricant is cheap. Use it liberally. Worn parts can be
expensive to replace.

Cub Cadet 1210 Specifications

General

Brand	Cub Cadet
Model	1210
Category	Tractor
Language	English