Cub Cadet 1210 User Manual

The lever is used to select any speed from a standstill
"N" position to eight miles per hour in the forward
direction and four miles per hour In the reverse
direction.
Moving the speed control lever fonward provides
increased fonward speed, and moving the lever
rearward provides the reverse speeds. (See Figures
5 or 6.)
S. SPEED CONTROL STOP (1210 and 1211
Tractors Only)
An adjustable speed control stop is provided to allow
the operator to return to a predetermined speed.
(See Figures 5 or 6.)
T. FUEL TANK FILLER CAP GAUGE
The fuel tank filler cap gauge indicates how much fuel
is present in the fuel tank. It also works as the fuel tank
cap. Remove the fuel tank filler cap gauge to fill the
fuel tank. Reinstall filler cap after filling tank. (See
Figure 4, 5 or 6.)
FUEL SHUT-OFF VALVE
The fuel shut-off valve which is located below the
gasoline tank is used as a main fuel shut-off to the
engine. To turn the fuel on, turn the knob
counterclockwise to the stop. To turn the fuel off, turn
the knob clockwise until it is tight.
HOOD AND NOISE ISOLATION PANELS
The tractor hood is arranged to swing up and forward
for easy access to the engine compartment. The
hood locks automatically when raised. (See Figure
17.) Whenever engine maintenance is required, the
noise isolation panels can be readily removed by
removing the two wing nuts and two washers (one on
each side) and disconnecting the panel spring.
Figure 17
1. Noise Isolation Panel (One on Each Side)
2. Panel Spring
3. Hood
OPERATION
A WARNING
RECEIVE INSTRUCTION - Read operator’s
manual. Learn to operate this machine
SAFELY. Don't risk INJURY or DEATH.
1. Before starting engine or operation: Be
familiar with controls. Be in operator’s
position with transmission in neutral,
PTO turned off. and brake depressed.
2. Keep shields in place. Stay away from
moving parts.
3. NO RIDERS! Keep all people and pets a
safe distance away. Look before back¬
ing up.
4. Don’t point mower discharge at people.
5. Avoid slopes. Tractors can be rolled
over.
6. Before leaving operator’s position: Shut
off PTO. Place transmission in neutral.
Set parking brake. Shut off engine.
Remove ignition key. Wait for all move¬
ment to stop before servicing or
cleaning.
7. Do not fill gasoline tank when engine is
running or while engine is hot. Tighten
cap securely.
11

Cub Cadet 1210 Specifications

General

Brand	Cub Cadet
Model	1210
Category	Tractor
Language	English