FIELD OPERATION
55
CONNECTING IMPLEMENT TO DRAWBAR
The correct connection of the implement to the drawbar will prevent stress
on both the tractor and the implement.
To assure proper tractor operation and optimum implement performance,
the implement must be connected to the drawbar correctly.
1. Connect pull-behind implements to the drawbar only.
2. Use a hardened steel hitch pin
to connect the implement to
the drawbar. Make sure the pin
is held securely in place with
a lock pin.
3. When working with the drawbar,
raise the lower links as high as
possible to prevent interference
between the lower links and
the implement.
4. The drawbar provides the
standard hitch distance from
the end of the PTO shaft to
the centerline of the rear hole
in the drawbar. This is necessary
for safe PTO operation of trailing
type equipment.
IMPORTANT: The maximum fixed drawbar vertical load is 440 Kg
PTO RPM
540
PTO SHAFT DIAMETER
1.375 In
(34.9 mm)
DIMENSION A
14 In
(358 mm)
REAR PTO SHAFT
REAR PTO SHAFT
DRAWBAR
To Next Page
Loading...
Need help?
General