EasyManuals Logo
Home>Cub Cadet>Tractor>GT2000

Cub Cadet GT2000 User Manual

Cub Cadet GT2000
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
15se c t i O n 5 — Op e r a t i O n
To use the REVERSE CAUTION MODE :
NOTE: The operator MUST be seated in the tractor seat.
Start the engine as previously instructed on the previous 1.
page.
Turn the key from the NORMAL MOWING (Green) position 2.
to the REVERSE CAUTION MODE (Yellow) position of the
key switch module. See Fig. 5-1.
Press the REVERSE PUSH BUTTON at the top, right corner 3.
of the key switch module. The red indicator light at the
top, left corner of the key switch module will be ON while
activated. See Fig. 5-1.
Once activated (indicator light ON), the tractor can be 4.
driven in reverse with the cutting blades (PTO) engaged.
Always look down and behind before and while backing to 5.
make sure no children are around. After resuming forward
motion, return key to the NORMAL MOWING position.
The REVERSE CAUTION MODE will remain activated until:
The key is placed in either the NORMAL MOWING a.
position or STOP position or
The operator leaves the seat.b.
Driving The Tractor
WARNING! Avoid sudden starts, excessive speed
and sudden stops.
Lightly press the brake pedal to release the parking brake . 1.
Move the throttle lever into the FAST position.
To travel FORWARD, slowly press the forward drive pedal 2.
forward until the desired speed is achieved. See Fig. 5-2.
To travel in REVERSE, check that the area behind is clear then 3.
slowly depress the reverse drive pedal until the desired speed
is achieved. See Fig. 5-2.
CAUTION: Do NOT attempt to change the
direction of travel when the tractor is in motion.
Always bring the tractor to a complete stop before
changing from forward to reverse or vice versa.
WARNING! Do not leave the seat of the tractor
without first placing the PTO/Blade Engage lever in
the OFF position and engaging the parking brake. If
leaving the tractor unattended, also turn the engine
off and remove the ignition key.
Driving On Slopes
Refer to the SLOPE GAUGE on page 8 to help determine slopes
where you may operate the tractor safely.
WARNING! Do not mow on inclines with a slope in
excess of 15 degrees (a rise of approximately 2-⁄
feet every 10 feet). The tractor could overturn and
cause serious injury.
Mow up and down slopes, NEVER across.•
Exercise extreme caution when changing direction on •
slopes.
Watch for holes, ruts, bumps, rocks, or other hidden •
objects. Uneven terrain could overturn the machine. Tall
grass can hide obstacles.
Avoid turns when driving on a slope. If a turn must be •
made, turn down the slope. Turning up a slope greatly
increases the chance of a roll over.
Avoid stopping when driving up a slope. If it is necessary •
to stop while driving up a slope, start up smoothly and
carefully to reduce the possibility of flipping the tractor
over backward.
Engaging the Parking Brake
NOTE: The parking brake must be set if the operator leaves the
seat with the engine running or the engine will automatically
shut off.
To set the parking brake:
Press the brake pedal completely down with your left foot 1.
and hold it in that position.
Lift the parking brake/cruise control lever upward and hold 2.
it in that position.
Figure 5-1
Forward Drive Pedal
Reverse Drive Pedal
Figure 5-2
R
Indicator
Light
Reverse
Push Button
Stop
Position
Start
Position
Reverse
Caution Mode
Position

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cub Cadet GT2000 and is the answer not in the manual?

Cub Cadet GT2000 Specifications

General IconGeneral
BrandCub Cadet
ModelGT2000
CategoryTractor
LanguageEnglish

Related product manuals