Cub Cadet I Series User Manual

ENGINE RELATED PARTS
5
Exhaust pipes
The exhaust pipes are manufactured by Cub
Cadet. To remove/replace the exhaust pipes:
1. Remove the muffler following the steps
described in the previous section.
2. Remove the mounting bolts using a 1/2” wrench.
See Figure 2.7.
3. DIscard the old exhaust gaskets. Clean all gas-
ket material from the cylinder head (and exhaust
pipe if it is being reused.
4. Using new gaskets, install the exhaust pipes fol-
lowing the above steps in reverse order.
Figure 2.7
Remove these bolts
Fuel tank removal/replacement
Remove/replace the fuel tank by following these steps:
1. Remove the deck.
2. Remove the fender by following the steps
described in Chapter 4: Body/Chassis.
3. Remove the hair pin clips retaining the deck lift
cables and disconnect the cables.
See Figure 2.8.
4. Unhook the deck lift assist spring.
See Figure 2.9.
! CAUTION! CAUTION
Gasoline and it vapors are
extremely flammable. Use common
sense when working around the fuel
system
Hair pin clip
Deck lift cable
Figure 2.8
Figure 2.9
Deck lift assist spring

Cub Cadet I Series Specifications

General

Brand	Cub Cadet
Model	I Series
Category	Tractor
Language	English