Cub Cadet LTX1042 User Manual

Figure 7-10
2.
baffle and the cutting blade to act as a stabilizer.

Remove the hex flange nut that secures the blade to the 

To properly sharpen the cutting blades, remove equal 4.
amounts of metal from both ends of the blades along the

angle. Always grind each cutting blade edge equally to

CAUTION: If the cutting edge of the blade has
previously been sharpened, or if any metal
separation is present, replace the blades with new
ones.
WARNING! A poorly balanced blade will cause
excessive vibration, may cause damage to the
tractor and/or result in personal injury.
5.
metal from the heavy side until it balances evenly.
NOTE: When replacing the blade, be sure to install the

a part number stamped in it) facing the ground when the
mower is in the operating position.
CAUTION: Use a torque wrench to tighten the


Battery
CALIFORNIA PROPOSITION 65 WARNING:

contain lead and lead compounds, chemicals known

reproductive harm. Wash hands after handling.
CAUTION: If removing the battery, disconnect the



(Red) wire its terminal first, followed by the

Jump Starting
WARNING! Never jump start a damaged or frozen

ignitions are off. Do not allow cable clamps to touch.
Connect the positive ( +) cable to positive (+) post of your

Connect the other end of the cable to the positive (2. +) post
of the jumper battery.
Connect the negative ( –) cable to the other post of the
jumper battery.
Make the final connection on the engine block of the 4.
tractor, away from the battery. Attach to an unpainted part
to assure a good connection.
CAUTION: If the jumper battery is installed on a

engine when jump starting your tractor.
5.
this manual).
6.
cables, in reverse order of connection.
Figure 7-9
27se c t i O n 7 — se r v i c e

Cub Cadet LTX1042 Specifications

General

Brand	Cub Cadet
Model	LTX1042
Category	Lawn Mower
Language	English