Bagger Assembly & Installation
Triple Upper Bagger Components
6
20
Assembling The Bag Support Assembly
Note: The boot mounting assemblies can accommodate either a
twin or triple bagger. Since in most cases a triple bagging kit will
be purchased to accompany this unit, a triple bagger is shown
below. For twin bagging upper component mounting, follow the
same instructions below.
Locate the upright support bracket and the bag support
assembly. Assemble it by following these steps:
Lay the bag support assembly topside down with the mounting 1.
bracket portion facing upwards.
Insert the notched end of the vertical support bracket into the 2.
bag support assembly, as in Fig. 6-1, and secure with a
carriage bolt (710-0276) and flange lock nut (712-04063)
packed in with these support assemblies. See Fig. 6-2.
Figure 6-1
Figure 6-2
Mount Assembly on Tractor
With the mounting bracket assembly previously installed on
the tractor along with the chute discharge elbow and chute
extension, install the bagger components onto the tractor as
follows:
Install the bag support assembly onto the mounting bracket 1.
assembly on the tractor by hooking it over the cross
mounting bracket outside of the two tabs. See Fig. 6-3.
Secure the bag support assembly in the left hole of the 2.
mounting bracket using a hex bolt (710-3008) and flange
lock nut (712-04063) provided in with the support bracket
kit you are installing. See Fig. 6-4.
Figure 6-3
Figure 6-4
To Next Page
Loading...
Need help?
General
