Bagger Assembly & Installation
Twin Upper Bagger Components
5
16
Assembling The Bag Support Assembly
Locate the upright support bracket and the bag support
assembly. Assemble it by following these steps:
Lay the bag support assembly topside down with the 1.
mounting bracket portion facing upwards.
Insert the notched end of the vertical support bracket into 2.
the bag support assembly, as in Fig. 5-1, and secure with
a carriage bolt (710-0276) and flange lock nut (712-04063)
packed in with these support assemblies. See Fig. 5-2.
Figure 5-1
Figure 5-2
Mount Assembly on Tractor
With the mounting bracket assembly previously installed on the
tractor along with the chute discharge elbow and chute extension,
install the bagger components onto the tractor as follows:
Install the bag support assembly onto the mounting 1.
bracket assembly on the tractor by hooking it over the cross
mounting bracket on the right side as shown in Fig. 5-3.
Secure the bag support assembly to the mounting 2.
assembly in the right side mounting hole using a hex bolt
(710-3008) and flange lock nut (712-04063) provided in
with the support bracket kit you are installing. See Fig. 5-4.
Figure 5-3
Figure 5-4
To Next Page
Loading...
Need help?
General
