DAP-1330
2
SETTING UP THE DAP-1330 USING WI-FI PROTECTED SETUP (WPS)
NOTE:
To connect to a wireless router or AP and extend the Wi-Fi network in your
home, please make sure the source router or AP features a WPS Button.
PRODUCT SETUP
SETUP
Plug the DAP-1330 into a wall outlet and wait until the
Status/WPS LED is blinking amber. Push the WPS
button on the source wireless router or AP, and then
push the WPS button on the DAP-1330. The Status/
WPS LED will start to ash green.
The DAP-1330 is now ready to share the extended
Wi-Fi network with your PCs and mobile devices.
Connect to the extension network created by the
DAP-1330 using the following network name (SSID):
• 2.4 GHz: (Your router’s SSID)-EXT
After WPS, the password of “(Your router’s SSID)-EXT”
will be the same as the router it is extending.
Please allow up to two minutes for the process to nish.
The Status/WPS LED will turn solid green when the
DAP-1330 has connected successfully to the source
wireless router or AP.
SELECT YOUR METHOD
There are three methods available for setting up the DAP-1330 - using WI-FI Protected
Setup (WPS) (recommended), the QRS Mobile App, or a web browser.
If the Signal Indicator LED has a single amber bar after
the connection process has nished, the DAP-1330 has
established a poor quality connection. To improve the
connection quality, the DAP-1330 should be relocated to
a wall outlet closer to the source wireless router or AP.
The more lit bars on the Signal Indicator LED, the better
the wireless signal.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
