DAP-400P Quick Installation Guide
Initial Configuration Wizard
In order to start the Initial Configuration Wizard manually, go to the Initial
Configuration section.
Click the OK button and wait until the factory default settings are restored.
If you perform initial configuration of the access point via Wi-Fi connection,
please make sure that you are connected to the wireless network of DAP-400P
(see the WLAN name (SSID) in the Default Settings section, page 3) and click
the NEXT button. Then click the START button.
If the device has not been configured previously or the default settings have
been restored, the Initial Configuration Wizard starts automatically upon
access to the web-based interface or upon opening a web site on the Internet.
20
To Next Page
Loading...
Need help?
General
