DAP-400P Quick Installation Guide
CONNECTING TO PC
PC with Ethernet Adapter
1. Сonnect an Ethernet cable between the LAN port of the access point and
the Ethernet port of your PC.
2. For a switch supporting PoE: connect an Ethernet cable between the
PoE-enabled switch and the WAN port of the access point.
3. For a switch not supporting PoE or router: connect an Ethernet cable
between the switch or router and any Ethernet port of the access point.
4. Connect the power adapter (not included in the delivery package) to the
power connector port on the back panel of the access point, then plug the
power adapter into an electrical outlet or power strip.
Now you need to configure an IP address for the Ethernet adapter of your PC.
5
To Next Page
Loading...
Need help?
General
