9
Software Installation
Using D-Link Click ‘n Connect
Turn on the computer and Insert the D-Link DCS-2121 Installation CD in the CD-ROM drive. Use the D-Link Click ‘n Connect utility for initial setup. The following
step-by-step instructions will be shown in Windows® XP. The similar steps and screens will be shown for other Windows operating systems.
The content of the Installation CD-ROM includes:
If the CD Autorun function does not automatically start on your computer, click Windows Start > Run. In the Run command box type “D:\DCC\D-Link.exe”, where D:
represents the drive letter of your CD-ROM. If it does start, proceed to the next screen.
On the rear panel of the camera a number, the MAC ID is printed. Write this number down, it
Select Language
Click on Start button
To Next Page
Loading...
Need help?
General