29
SETUP
This section allows you to further set up or change the configuration of your IP camera.
SETUP > Wizard
The setup wizards guide you through initial setup of your IP camera. You can use the Internet
Connection Setup Wizard for initial network setup, and you can use the Motion Detection Setup
Wizard to set up motion detection and snapshots. Simply follow the instructions given in each
step of the wizard to quickly set up your camera.
Alternatively, you can manually set up your Internet connection by clicking Manual Internet
Connection Setup, and you can manually set up motion detection options by clicking on
Manual Motion Detection Setup. You can also see these settings by clicking on their
categories on the left side (Network Setup / Wireless Setup / Motion Detection / Snapshot).
Note: If the camera is set to SXGA mode in Audio and Video, Motion Detection and Motion
Triggered Snapshots are disabled.
To Next Page
Loading...
Need help?
General