D-Link DES-1005D User Manual

FCC Certifications
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Shielded interface cables must be used in order to comply with emission limits.
You are cautioned that changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
This device must accept any interference received, including interference that may
cause undesired operation.
CE Mark Warning
This is a Class B product. In a domestic environment, this product may
cause radio interference, in which case the user may be required to take
adequate measures.
VCCI Warning

D-Link DES-1005D Specifications

General

Forwarding rate	0.1488 Mpps
MAC address table	2000 entries
Store-and-forward	Yes
Packet buffer memory	0.046875 MB
Maximum data transfer rate	0.2 Gbit/s
Supported data transfer rates	10/20/100/200 Mb/s
10G support	No
Networking standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3x
Cable types supported	Cat3, Cat4, Cat5, Cat5e
Copper ethernet cabling technology	100Base-TX, 10Base-T
Heat dissipation	8.528 BTU/h
Storage temperature (T-T)	-10 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	10 - 90 %
Power consumption (typical)	2.5 W
Switch type	Unmanaged
Switch layer	-
Certification	RoHS, FCC, CE
Product color	Black
LED indicators	LAN, Power
Package depth	105 mm
Package width	65 mm
Package height	98 mm
Package weight	170 g
Cables included	AC
Packet transfer speed	14880 - 148800 p/s
Power connector	DC-in jack
Installed SFP modules quantity	0
Basic switching RJ-45 Ethernet ports type	Fast Ethernet (10/100)
Basic switching RJ-45 Ethernet ports quantity	5
Pallet width	1200 mm
Pallet length	1100 mm
Pallet height (air)	1975 mm
Pallet gross weight (air)	465250 g
Quantity per pallet (air)	2400 pc(s)
Shipping (inner) case width	350 mm
Shipping (inner) case height	230 mm
Shipping (inner) case length	515 mm
Shipping (inner) case weight	9250 g
Shipping (inner) case net weight	8500 g
Number of cartons per pallet (air)	48 pc(s)
Quantity per shipping (inner) case	50 pc(s)
Harmonized System (HS) code	85176990

Weight and Dimensions

Depth	83.4 mm
Width	125.3 mm
Height	29.1 mm